Help with Command Timeouts
Command timeouts are possible in all areas of the DSP. If interfaces, events or validations are timing out, try these two solutions:
- Increase the Connection Timeout for the InterfaceServer Data Source. Do not increase beyond 3500 seconds.
- Check the timeout settings for the Data Sources used in the events. Do not increase beyond 3500 seconds.
Timeout settings are set on the Data Sources page on the Advanced Properties tab in System Administration.
Was this article helpful?
Sorry about that.
Why wasn't this helpful? (check all that apply)
Thanks for your feedback.
Want to tell us more?
Send an email to our authors to leave your feedback.
Great!
Thanks for your feedback.